haserltd.blogg.se - Speedtouch ip address default

SPEEDTOUCH IP ADDRESS DEFAULT HOW TO
SPEEDTOUCH IP ADDRESS DEFAULT PASSWORD

The remaining settings can be left as they are.

The Gateway Address should also be set to the new Router address ( 192.168.0.254 in our example).

The Server Address should be set to the same as the new Router address ( 192.168.0.254 in our example).

The Subnet Mask should be set to the Subnet mask of your new IP range.

Set the End IP address to the last DHCP assignable address of your new range (in our example 192.168.0.253).

Set the Start IP Address to the first DHCP assignable address of your new range (in our example 192.168.0.64).

Click the Add button at the bottom of the IP Addresses section.Ĭlick on the Edit link in the DHCP Pools section.

Fill in the new IP address and subnet Mask for the router in the boxes under the IP Addresses section.

Remove the tick from the box: Use DHCP Server and then click Apply.

SPEEDTOUCH IP ADDRESS DEFAULT PASSWORD

LAN configuration:įirstly you should log onto the SpeedTouch router's Web configuration page (which can be found at by default.) The default username is Administrator, and the password is left blank.Ĭlick on the Office Network option in the left-hand menu.Ĭlick on the Interfaces option, and then click on the lan1 interface on the right-hand side.Ĭlick on Configure at the top right of the screen

This article steps though the example of reconfiguring a SpeedTouch 608WL from its default IP address of 192.168.1.254 (with subnet mask 255.255.255.0) to an address of 192.168.0.254. You may need to make these changes in order to use your SpeedTouch router with your existing LAN configuration, or in order to change the LAN subnet at one side of a VPN tunnel.

SPEEDTOUCH IP ADDRESS DEFAULT HOW TO

This article shows how to change the LAN IP address settings on a SpeedTouch 608 series router.